LED Controller status
Green Controller is connected to the headset.
Blinking blue and red alternately Controller is updating firmware.
Off Controller is idle.
How do I check the power level of my controllers?
To check the power level of your controllers, put on the headset and do any of the following:
§ Look down at the dashboard. Use your controller to select any of the icons on the top-right
corner of the dashboard.
You'll then see the power level of the controllers.
§ From the dashboard, go to Settings Inputs Controller.
What should I do if I can't see my controllers in VR?
Once paired with the headset, your controllers will automatically be detected when they're on. If
you don't see them in VR, try one of the following:
§ The controllers may be in sleep mode. Shaking them gently will wake them up.
§ If your controllers are off, turn them on by briefly pressing the VIVE button on the right
controller and the Menu button on the left controller. The controller LEDs will turn blue
while they are connecting, or green when they are connected.
§ If the controllers can't be detected after you installed a firmware update, press and hold
the VIVE and Menu buttons to restart both controllers.
§ Make sure your controllers are charged. A flashing red LED indicates low power. If the
controllers are low or don't respond, try charging them. See Charging the controllers on
page 14 for details.
§ If your controllers are on but still not being detected, you might need to pair them again.
See Pairing controllers on page 21.
62 Solutions and FAQs
To Next Page
Loading...
