HTD Lync - Product Features

Lync 6 Controller
Included with Lync 6
LyncPad
3
Product Features
(1) Power cord
(6) Shielded Stereo Patch Cable (3 feet long)
(for connecting each zone to the multi-channel amplier)
(1) 3.5mm (mono) trigger cable
Power
123456 123456
789101112
Zone Status Source Signal Strength
AC 120V~60Hz
FUSE T2AL/250V
Power Consumption: 160W
ROUTED IR OUT
SOURCE INPUT
KEYPAD PORTS
7
8
9
10
11
12
MP3
L
ZONE 1 PREOUT ZONE 2 PREOUT ZONE 3 PREOUT ZONE 4 PREOUT ZONE 5 PREOUT ZONE 6 PREOUT
MONO STEREO MONO STEREO MONO STEREO MONO STEREO MONO STEREO MONO STEREO
R
LRLR
LRLR
LRLRLRLR
LRLRLR
R
L
43
2
1
56
IR IN
RS232
INTERFACE
GLOBAL
IR OUT
12V/DC
TRIGGER
100mA
IN OUT
System
TRIGGER
AC/DC 3-20V
Mute
Made in Ta iwan
CAUTION
To Prevent Electric Shock,
Do Not Remove Cover. No
User-Serviceable Parts Inside,
Refer Servicing To Qualified
Service Personnel.
WARNING
To Prevent Fire Or Shock
Hazard, Do Not Expose This
Unit To Rain Or Moisture.
FIXEDVARIABLE
IR IN
SOURCE 7
Power On/Off button
5 Source inputs
USB Flash Drive (MP3) Input
IR Input (connect to IR receiving
eye - sold separately)
Global IR Output - Passes IR
signals via a single or dual IR
emitter regardless of Source
selected by a zone
Routed IR Outputs - Pass IR
signals via a single IR emitter
only to the Source selected
bya a zone
RJ-45 input (for Cat 5
cable to LyncPad)
Zone Output - Fixed
Variable
Zone Output - Mono/
Stereo Switch
Trigger Out
RS232 Interface - for system control
and customization through PC
System Mute
Trigger In
Zones 1 - 6 DI-21 Interface Input
Power Plug
Zone Status indicates when a zone is
powered on.
Source status indicates the strength
of an input signal
LCD Screen
Volume Control
Power/Mute
IR receiving eye
Magnetically
attached frame
3.5mm Source input
Talk (intercom) button
Zone selection
(intercom)
Do Not Disturb
Source Selection
RJ-45 connectors
(Cat 5 to Lync)
5-pin connection
source input panel
Buttons for
controlling MP3
player
Vo l
Vo l
Source
Zone
Talk
Source InPower/Mute
DND
Vo l
Vo l
Source
Zone
Talk
Source InPower/Mute
DND
NOTE:The LyncPads are connected to the Lync using Cat5e cable (Cat5, or Cat6 will also work and can be used in place of
Cat5e throughout this manual) with RJ-45 connections at both ends.