Need help?Do you have a question about the HTD Lync and is the answer not in the manual?
General| Frequency Response | 20Hz - 20kHz |
|---|---|
| Total Harmonic Distortion | <0.1% |
| Signal to Noise Ratio | >90dB |
| Zone Trigger Output | 12VDC |
| Speaker Impedance | 8 Ohm |
Details on setting amplifier levels, input selection, and channel output switches.
Configuration of bridge switches, trigger switches, and trigger cable connections.
Instructions on how to attach IR emitters to control devices effectively.
Controls for volume, source selection, mute, power, party mode, and DND.
How to access and adjust LyncPad settings like bass, treble, and brightness.
How to select zones, talk, handle DND, and understand volume settings.
Step-by-step guide for wiring the doorbell to the Lync controller's mute feature.
Details on T-568A/B standards, crimping tools, and cable preparation.
Steps to configure Skype™ for automatic call answering and contact management.
List of codes for ringing or talking to specific zones or all zones.
How to properly end calls and best practices for disconnection.
To Next Page
