FOR OUR LATEST PRODUCTS & OFFERS VISIT WWW.HTL-WORLDWIDE.COM
14
IMPORTANT: Always attempt one nal cycle to ensure the stall point has been reached.
Loosening Procedure
First, set the pump to 10,000 psi. Change the drive and the reaction arm to the loosening mode,
ensuring the reaction arm abuts squarely o a solid reaction point. Press and hold the remote control
button down. Pressure will decrease as the socket begins to turn. As the cylinder extends fully, you will
hear a click. Release the remote control button, and the cylinder automatically retracts, at which time you
again hear the click. Repeat this process until the fastener can be removed by hand.
NOTE: If the bolt does not loosen with the above procedure. it is an indication that you require the next
larger size tool to loosen the bolt.
HTL-Operating-Instructions-DS.indd 15 11/04/2017 10:15
To Next Page
Loading...