2
Manufacturer’s Warranty
It is expressly agreed that there are no warranties, expressed or implied, made by either the Salesman, Dealer, or HTP
America, Inc. on products or parts furnished hereunder, except the Manufacturer’s Warranty against defective materials
or workmanship as follows:
HTP America, Inc. warrants each new welding machine to be free from defects in material and workmanship under
normal use and service for three (3) years after delivery to the original purchaser. HTP America, Inc. will repair or
replace, at its factory, any part or parts thereof. Products should be returned to HTP America, Inc., with transportation
charges prepaid, and which its examination shall disclose to its satisfaction to have been thus defective. This warranty
being in lieu of all other warranties, expressed or implied, and all other obligations or liabilities on its part and it neither
assumes nor authorizes any other person to assume for it any other liability in connection with the sale of its machines.
This warranty shall not apply to any welding machine which has been repaired or altered by unauthorized service
departments in any way so as, in the judgment of HTP America, Inc., to affect its stability and reliability, nor which has
been subjected to misuse, negligence, or accident.
HTP America, Inc. shall not be liable in any event, unless HTP America, Inc. receives notice of alleged breach of
warranty, specifying the claimed defect, within not more than thirty (30) days after discovery.
HTP America, Inc. has reserved the right to make changes in design and/or add any improvements to its product at any
time without incurring the obligation to install the same on equipment.
This warranty is void unless warranty card is sent to HTP America, Inc. within fifteen (15) days from the date of
purchase.
Exclusions to Warranty:
The electrode holder and ground clamp is warrantied for a period of ninety (90) days against defects in material and
workmanship.
NOTE: This warranty is to the original purchaser only. The warranty can be transferred to another owner, with HTP’s
approval, for a warranty transfer fee. HTP America, Inc. must be notified within fourteen (14) days of the sale and must
be provided with the contact information of the original owner, the contact information of the new owner, and the serial
number of the machine.
Safety Suggestions
People with PACEMAKERS should not use or come near the InverArc 160 Plus when in use.
Electric arc welding produces ultra-violet rays which are harmful to skin and eyes. Ultra-violet radiation can
penetrate lightweight clothing, reflect from light-colored surfaces, and burn the skin and eyes.
• Wear a heavy, pocket-less, long-sleeved shirt, cuff-less trousers, and high-topped work shoes.
• Wear a full-faced welding helmet with a number ten (10) or darker shade and a cap.
Electric arc welding produces flying sparks and hot material, which can cause fire.
• Wear non-oily/non-greasy, flameproof welding gloves; the oil or grease on the gloves may ignite.
• To avoid fire, do not weld on wood, plastic tile, or carpeted floors. Concrete or masonry floors are safest.
• Do not weld on pressurized containers
• Do not weld on drums, barrels, tanks, or other containers until they have been cleared and cleaned as described
in AWS Standard A6.01.
• Do not weld near flammable materials.
To Next Page
Loading...
