16
SECURITY CHARACTERISTICS
The max inlet pressure is 0.8MPa.
● Following warming sentences:
If the supply cord is damaged. it must be replaced by
the manufacturer, its service agent or similarly qualied
persons in order to avoid a hazard.
● The pressure-relief device is to be operated regularly to
remove lime deposits and to verify than is not blocked.
● CAUTION: In order to avoid a hazard due to inadvertent
resetting of the thermal cut-out, this appliance must be
not supplied through an external switching device, such
as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
● This appliance can be used by children aged from 8 years
and above and persons with reduced physic sensory or
mental capabilities or lack of experience and knowledge
if they have been given supervision instruction concerning
use of the appliance in a sate way and understand
the hazards involved. children shall not play with the
appliance, cleaning and users maintenance shall not
made by children without supervision.
● This electrical water heater must be installed with a
mono-directional safety valve at the inlet pipe(blue
indicator) when the tank’s pressure is over 0.8 MPa, this
will automatically active the safety valve, water will exit
at the drain pipe outlet (Diagram1). In any condition, this
outlet must not be blocked.
If there is a need to empty the water in the tank, rst,
close the mains water. Remove the xed screw nail on the
safety valve. lift up the plastic handle
(see diagram 2) to let the water ow out naturally.
To Next Page
Loading...
