l Extended Service Set (ESS) in Fit AP mode
l Wireless distribution system (WDS) in Fit AP mode
l Mesh networking in Fit AP mode
l Multi-user CAC
3.2 Network Features
Network features supported by the AP are as follows:
l Compliance with IEEE 802.3u
l Auto-negotiation of the rate and duplex mode and automatic switchover between the
Media Dependent Interface (MDI) and Media Dependent Interface Crossover (MDI-X)
l Compliance with IEEE 802.1q
l SSID-based VLAN assignment
l VLAN trunk on uplink Ethernet ports
l Management channel of the AP uplink port in tagged and untagged mode
l DHCP client, obtaining IP addresses through DHCP
l Tunnel data forwarding and direct data forwarding
l STA isolation in the same VLAN
l Access control lists (ACLs)
l Link Layer Discovery Protocol (LLDP)
l Uninterrupted service forwarding upon CAPWAP channel disconnection in Fit AP mode
l Unified authentication on the AC in Fit AP mode
l AC dual-link backup in Fit AP mode
l Network Address Translation (NAT) in Fat AP mode
l IPv6 in Fit AP mode
3.3 QoS Features
QoS features supported by the AP are as follows:
l Priority mapping and packet scheduling based on a Wi-Fi Multimedia (WMM) profile to
implement priority-based data processing and forwarding
l WMM parameter management for each radio
l WMM power saving
l Priority mapping for upstream packets and flow-based mapping for downstream packets
l Queue mapping and scheduling
l User-based bandwidth limiting
l Adaptive bandwidth management (automatic bandwidth adjustment based on the user
quantity and radio environment) to improve user experience
l Airtime scheduling
AP4050DN-E
Product Description
3 Product Features (in Fat AP and Fit AP Modes)
Issue 01 (2016-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
14
To Next Page
Loading...
Need help?
General
