3 Product Features (in Fat AP and Fit AP
Modes)
3.1 WLAN Features
WLAN features supported by the AP are as follows:
l Compliance with IEEE 802.11a/b/g/n/ac/ac Wave 2
l Maximum rate of 1.267 Gbit/s
l Maximum ratio combining (MRC)
l Space time block code (STBC)
l Beamforming
l MU-MIMO
l Low-density parity-check (LDPC)
l Maximum-likelihood detection (MLD)
l Frame aggregation, including A-MPDU (Tx/Rx) and A-MSDU (Rx only)
l 802.11 dynamic frequency selection (DFS)
l Short guard interval (GI) in 20 MHz, 40 MHz, and 80 MHz modes
l Priority mapping and packet scheduling based on a Wi-Fi Multimedia (WMM) profile to
implement priority-based data processing and forwarding
l Automatic and manual rate adjustment
l WLAN channel management and channel rate adjustment
NOTE
For details about WLAN channel management, see the Country Code & Channel Compliance
Table.
l Automatic channel scanning and interference avoidance
l Service set identifier (SSID) hiding
l Signal sustain technology (SST)
l Unscheduled automatic power save delivery (U-APSD)
l Control and Provisioning of Wireless Access Points (CAPWAP) in Fit AP mode
l Automatic login in Fit AP mode
AP4050DN-E
Product Description
3 Product Features (in Fat AP and Fit AP Modes)
Issue 01 (2016-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13
To Next Page
Loading...
Need help?
General
