NOTE
The length of six adjacent mounting holes may not be 2 U. Observe the scale ticks on the mounting rails when
installing floating nuts.
You can use a flat-head screwdriver to install floating nuts.
NOTE
The length of six adjacent mounting holes may not be 2 U. Observe the scale ticks on the mounting rails when
installing floating nuts.
You can use a flat-head screwdriver to install floating nuts.
Scenario 4: Installing the Router in a Cabinet (Using a 550 Horizontal Rack-Mounting Kit)
There must be a clearance larger than or equal to the router's width at the left and right of the router after the
installation. The clearance above the router must be at least two times the router's height and the clearance below
the router must be greater than or equal to the router's height.
CAUTION
5
6
Install two floating nuts on each front mounting rail of the cabinet. Leave four mounting holes between the
two floating nuts on the same mounting rail.
Use the Phillips screwdriver to install M6 screws on the two lower floating nuts, and leave 2 mm of the
screws out of the floating nuts.
Move the router into the cabinet with one hand supporting bottom of the router, and hook the brackets at
both sides of the mounting kit on the M6 screws.
Use the Phillips screwdriver to tighten the lower M6 screws and then the upper M6 screws.
1
Install two floating nuts on each front mounting rail of the cabinet. Leave four mounting holes between the
two floating nuts on the same mounting rail.
2
Attach the brackets of the 550 horizontal rack-mounting kit on the front mounting rails of the cabinet and
insert M6 screws in the mounting holes. Use a Phillips screwdriver to tighten the lower M6 screws and then
the upper ones to fix the rack-mounting kit.
4
7
5
2
m
m
6
75
×4
2U
1 2
To Next Page
Loading...
