Huawei AR530 Series - Page 7

Scenario 5: Mounting the Router in a Cabinet (Using a Mounting Kit)
There must be a clearance larger than or equal to the router's width at the left and right of the router after the
installation. The clearance above the router must be at least two times the router's height and the clearance below
the router must be greater than or equal to the router's height.
CAUTION
3
Screw lock nuts on the hex bolts and fix the hex bolts on the mounting bracket.
Hang the mounting bracket on the DIN rail.
Use a combination wrench to screw the hex bolts on the mounting bracket.
When the DIN rail is fixed with the raised hex bolts, tighten the lock nuts by
rotating the wrench counterclockwise.
Align an M4x20 screw with the topmost tapped hole on the mounting
bracket, and screw it about 5 mm into the tapped hole with the Phillips
screwdriver.
Use two M4x20 screws to fix the stainless steel sheet on the router.
Loosen the screws on the front top cover with the Phillips screwdriver, remove the front top cover, and
keep it in an appropriate place for later use.
Hang the router onto the topmost screw on the mounting bracket and adjust position of the router to
align the mounting holes on the router with those on the mounting bracket. Use two M4x30 screws to
fix the router onto the mounting bracket and tighten the topmost screw on the mounting bracket.
Loosen the screws on the front top cover with a Phillips screwdriver, remove the front top cover, and
keep it in an appropriate place for later use.
5
6
4
7
8
9
1
6
7
Lock Nut
3
5
AR530
Series
INFRARED
PWR
RUN/ALM
RS485-0
RS485-1
AR531-F2C-H
1
2
9
L1 L2
L3
FE5
FE4
FE3
FE2
N
A
RS485-
0
B
A
RS485-
1 DI-0
DI-1
B
GE0
RX TX
GE1
MONI
TO
R
Power Outage Survival
RX TX
FE6
FE7
CONSOLE
8