Huawei E220 - 9 SMS; Sending or Receiving a Message

HUAWEI
20
9 SMS
Sending or Receiving a Message
Creati Message ng a
or select Tools > SMS, the SMS interface is displaClick yed.
St ep Operation
1 Click Write, and the Write interface is displayed.
2
z
d
s
sp
4
z auto
mpt is displayed
z Click Save to save the message to the Draft.
z Click Clear to clear the phone number and the message.
E
z Enter the phone number: In the Contacts field, enter the phone
number and use the semicolon to separate phone numbers.
Select the contact: Click Contacts. Select one or more contacts and
nter the phone number by one of the following ways:
click OK. In the pop-up dialog box, select the phone numbers an
click OK. To select several contacts, select the Apply to all item
check box to simplify the procedures.
3
Write the message. On the upper right corner of the interface, the
number of remaining characters and the number of the message is
lit are displayed.
Click Send to send the message. After the message is sent, it is
saved to the Outbox. If the sending fails, a pro
asking whether to send it again. If you cancel
the sending, the
message is auto saved to the Outbox.