6
When WPS is enabled, press and hold the button for one to five seconds to set up a 2.4 GHz
WPS connection, or press and hold the button for more than five seconds to set up a 5 GHz WPS
connection.
○,
10
Power button
Press this button to power the CPE on or off.
○,
11
Power port
Connect to the CPE's power adapter.
○,
12
USB port
Connect to a USB storage device or USB printer.
Note:
z The CPE supports USB 1.1 and 2.0 storage devices in FAT16, FAT32, ext2, and ext3
formats. Storage devices with power supply requirements exceeding USB standards may
not work properly. It is recommended that you prepare an external power supply in these
cases.
z The CPE is compatible with samba-supported USB printers.
z This port cannot be connected to USB host devices, such as computers.
○,
13
TEL ports (RJ11)
Connect to telephones or a fax machine.
Note:
Do not connect a telephone and fax machine to the CPE simultaneously.
○,
14
LAN ports (RJ45)
Connect to computers, switches, or other network devices.
○,
15
LAN4/WAN port (RJ45)
Connect to an Ethernet port, computer, switch, or other network device.
○,
16
LAN4/WAN indicator
z On: The port is connected to an Ethernet port or device.
z Blinking: Data is being transmitted through the port.
To Next Page
Loading...
