Step 5
Set the IP STB to access the network through the PPPoE dial-up mode.
Connecting a Computer to a Wireless Network
Suppose that a wireless router supporting the WPS function has been installed in your
home, and you want your computer to access the network wirelessly. In this case, you
can also use the WS311 to implement the wireless connection.
This section describes how to connect and configure the WS311 by supposing that the
computer accesses the wireless network by using the routing function of the wireless
router.
Step 1
Configure the wireless router.
1.
2.
3.
1.
2.
Set the WAN interface to access the network by using the PPPoE dial-up
mode.
Enable the routing and Dynamic Host Configuration Protocol (DHCP)
functions.
Enable the wireless network function and enable the WPS function
implemented through the PBC method.
Step 2
Connect the WS311.
Connect the LAN interface of the WS311 to the Ethernet interface of the
computer by using a network cable.
Connect the POWER interface of the WS311 to the power socket by using a
power adapter.
Step 3
Power on the WS311.
Step 4
Press the WPS button of the wireless router. Within two minutes, press and
hold the WPS button of the WS311 for over 2s, and then release it.
Wait for a moment. When the wireless network indicator of the WS311 turns
solid orange, it indicates that the WS311 successfully connects to the wireless
router through the wireless network.
Step 5
Set the computer to obtain an IP address automatically for setting up a network
connection.
After the computer obtains the IP address allocated by the wireless router, you
can access the Internet by using the computer.
12
To Next Page
Loading...
Need help?
General
