Huawei eSpace IAD101H

eSpace IAD101H/102H/104H Integrated Access
Device
Quick Start
5 Configuration (EMS)
Issue 03 (2012-06-11)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
27
Operation
Command
Default Value
Set the parameters
for handshake
between the IAD
and the UCEMS
nms handshake

switch: on

interval: 30
Set the parameters
for communication
between the IAD
and the UCEMS
nms

getcom: public

setcom: private

trapcom: public

trapport: 162

register: on
Set the physical
serial number
(which consists of
1 to 64 characters)
physical-serial-num
Unique physical serial
number of each IAD.
Step 4 Run the write command to save the settings.
Run the display nms command to view status of the IAD registering to the UCEMS.
TERMINAL#display nms
the config is IP /*It indicates that the address of the UCEMS has
set through a domain name.*/
------------------------------------------------------------------
------
type IP address status
primary 192.168.1.201 normal
secondary <unconfig> unconfiged
------------------------------------------------------------------
------
get community : ********
set community : ********
trap community : ********
trap port : 162
nms access value: Enable
register nms ip : 192.168.1.201
register state : succeed
handshake : on
handshake time : 30 S
register switch : on
If the "register state" field displays "succeed", it indicates that the IAD has registered to
the UCEMS successfully.
----End