1. A UPS2000-G-6 kVA/10 kVA requires one battery pack to provide standard backup time, and
requires two to four battery packs to provide long backup time. For a UPS that provides long
backup time, battery packs connect to each other in parallel and then connect to the UPS battery
input port. The following figure shows how to connect four battery packs in parallel.
2. If the number of UPS2000-G-6 kVA/10 kVA parallel system is greater than or equal to 3, each
UPS can be configured with one to four battery packs. The installation methods for each UPS and
battery pack in the parallel system are the same as those in a single UPS system. The installation
sequence is: UPS > battery pack > UPS > battery pack … UPS > battery pack.
A. One 15 kVA/20 kVA UPS + Four battery packs
B. Two 15 kVA/20 kVA UPSs (1+1 parallel
system) + Four battery packs (shared)
C. Two 15 kVA/20 kVA UPSs (1+1 parallel
system) + Eight battery packs (not shared)
3. The following figures show three methods for installing the UPS2000-G-15 kVA/20 kVA and
battery packs.
Battery packs
Battery packs
Battery packs
Battery packs
…
Battery
pack 1
UPS Battery
input
Battery
pack 2
Battery
Pack 3
Battery
Pack 4
Battery cable
Battery
pack 1
UPS Battery
input
Battery
pack 2
Battery
Pack 3
Battery
Pack 4
Battery
pack 1
UPS Battery
input
Battery
pack 2
Battery
Pack 3
Battery
Pack 4
Battery
pack 1
UPS Battery
input
Battery
pack 2
Battery
Pack 3
Battery
Pack 4
To Next Page
Loading...
