Huawei ETS2506 - Answering a Call; Hands-Free Mode Switchover

6
6
B
B
a
a
s
s
i
i
c
c
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
s
s
HUAWEI
37
Redialing
In the standby state, press <CALL/REDIAL> to dial out the latest number you
dialed.
Answering a Call
In the FWT stand-by status, you can select to.
z Pick up the handset to answer a call;
z Press <HANDFREE> to answer a call;
z Press <CALL/REDIAL> to answer a call;
z Press <END> to refuse a call.
Besides, you are allowed to answer any call except when the FWT is in the
conversational status. When you hear a ringing of an incoming call,
z If the handset is already picked up, press <HANDFREE> or
<CALL/REDIAL> to answer the call;
z If <HANDFREE> is already pressed down, pick up the handset or press
<CALL/REDIAL> to answer the call.
 Note:
z Pressing <END>, you can hang up the call during the conversation and
replace the handset or press <HANDFREE> again (depending on the
state you answer the call) so that the FWT can return to standby state;
z Call ID Display (CID) service needs special commission from telecom
carriers. For more information, consult the local carrier.
Hands-free Mode Switchover
If you were in handset conversation mode and wanted to switch to hands-free
conversation mode, press <HANDFREE> and put back the handset after seeing
appearing. Then, you can talk in hands-free conversation mode.
You can switch to handset conversation mode from hands-free conversation
mode by directly picking up the handset.