8
• Once a second call has been established then two further menu options
becomes available:
• Swap is available, to allow the user to swap between the two calls, the one on hold
and the active call.
• Conference is also available, allowing the user to connect all three parties together
in a single conference call, (in fact up to 6 additional parties can be added to a
single call).
In addition to using the Options menu users can also press one of the feature shortcut
keys on the left of the unit, allowing the below behaviour during active calls:
• Button 1: Place the active call on HOLD
• Button 2: Transfer a call on hold to a third party, by pressing TRANS
• Button 3: Join active calls into a single conference, by pressing CONF.
Set up a conference call
• To set up a conference call, dial the 1st number to be added.
• Then press the HOLD feature access key.
• Then dial the next number to be added to the conference.
• Then press the CONF feature access key.
For additional members (max. 6, 7 including leader) repeat the last 2 steps.
Making a call with a headset
• In standby mode, press the number keys to enter a phone number.
• Press the call key to dial the number.
• Press the end key to end the call or cancel the dialing.
Switching to headset (not supplied)
• Plug in headset to microphone and headphone sockets.
• Lift receiver and make a call to a third party.
• Answer the call.
• Select Options and scroll down to Switch to headset and press Select.
• Replace the handset to the cradle.
• Headset audio or receiver can now be used for all subsequent calls whilst headset
is connected.
• To return to receiver only, unplug the headphones and microphone.
Notes:
• The headset will be used for all subsequent calls until the user unplugs the microphone
and headphones.
V5102C00310-One Net Desk Phone Guide-EH-V7.indd 8 25/04/2012 15:47
To Next Page
Loading...
