FTK01 & FMC2105-SU
FTTR Fiber Termination Kit & Field Mountable Connector
Quick Installation Guide
4 Processing the Optical Fiber
Copyright © Huawei Technologies Co., Ltd.
4 Processing the Optical Fiber
The operations for processing optical fibers are the same for different types of optical cables. The
following uses a 1.2 mm x 1.6 mm transparent optical cable as an example.
Step 1 Open the coating stripper. On the side marked with "Remove fixed length coating", route the
bare fiber through the hole near the shaft until the optical cable is clamped into the coating
stripper.
Clean the tool before stripping the optical fiber. Otherwise, the residual coating may cause
incomplete stripping of the optical fiber.
Do not leave a gap between the optical cable and the stripper.
To Next Page
Loading...
