Huawei FTK01 - Installing the Optical Fiber Connector

FTK01 & FMC2105-SU
FTTR Fiber Termination Kit & Field Mountable Connector
Quick Installation Guide
5 Installing the Optical Fiber Connector
Issue 02 (2023-05-22)
Copyright © Huawei Technologies Co., Ltd.
15
5 Installing the Optical Fiber Connector
The procedures for installing fiber connectors for different types of optical cables are similar. The
following uses a 1.2 mm x 1.6 mm transparent optical cable as an example.
Step 1 Install the matching piece for the 1.2 mm x 1.6 mm transparent optical cable at the optical
cable stripping point. Ensure that the top end face of the matching piece is flush with the
stripped end face of the optical cable.

Perform this step only for 1.2 mm x 1.6 mm transparent optical cables. For other types of optical
cables, skip this step.

When clamping the optical cable into the matching piece, ensure that the optical cable is completely
clamped.
Step 2 Ensure that the lock of the optical fiber connector is in the ON position. Push the optical cable
into the main body of the optical fiber connector until it reaches the end. In this case, the bare
fiber is slightly bent. Pay attention to the direction of the optical cable when pushing it into
the connector.