Huawei FusionServer G5500 - Page 55

54
www.huawei.com ▪ Huawei Confidential ▪ 54
Inspur: NF5288M5(AGX-2)
Parameter
G5500
-G560
Inspur NF5288M5(AGX
-2)
Dimensions (H x W x D)
4U (175*447*790)
2U (448*899.5*87.5)
Architecture
Modular
Integrated
CPU
2S + 24DIMM
2S + 16DIMM
Maximum CPU power
145 W (the model can be expanded to
205 W)
165 W
GPU
8*P100/P40
8*P100/V100 NVLink or P100/P40 PCIe
Maximum GPU power
350 W
300 W
CPU:GPU topology
1:8/1:4 flexible configuration
1:8
Hard drive
6*2.5'' NVMe SSD
2*2.5'' SAS/SATA HDD
8*3.5'' HDD
8*2.5 NVMe/SAS/SATA SSD/HDD
RAID
RAID 0/1/10/5/50/6/60
RAID 0/1/10/5/50/6/60
PCIe expansion
4*PCIe x16 LP
2*PCIe x16 LP (front panel) + 4*PCIe x16 LP (rear
panel in the case of
NVLink)
On
-board network adapter
4*10GE
Power supply
4*2200 W hot swap, 2+2
2*3000 W hot swap, 1+1 (the power modules
locate at the front and are routed to the rear)
Fan
6 hot swap,
5+1
The built
-in fans do not support hot swap. When
the fan fails, heat dissipation is affected.
Temperature
5
°C to 35°C
5
°C to 35°C
Beating Points
• The integrated design of the chassis does not support independent evolution of the CPUs and GPUs.
• Scalable Processors are supported but only up to 165 W, which is difficult to expand in the future. (Note that Huawei
G5500 supports only v4 processors.)
• PCIe GPU model. Only the front panel supports 2*PCIe x16 LP cards, and the cards block air ventilation.
• The maximum power consumption of the power module is 3000 W. When NVLink GPUs are used, the full-load power
consumption exceeds 3000 W, which does not support 1+1 redundancy.
• The power modules locate at the front and are routed to the rear of the chassis.