Port Type Quantity Description
Serial port RJ45 1 Default operating system
serial port used for debugging.
You can also set it as the iBMC
serial port by using the iBMC
command.
NOTE
The port uses 3-wire serial
communication interface, and the
default baud rate is 115,200 bit/s.
PSU socket - 2 Used to connect to the power
distribution unit (PDU) in the
cabinet. You can select the
number of power supply units
(PSUs) as required.
NOTE
● When determining the
quantity of PSUs, ensure that
the rated power of the PSUs
is greater than that of the
server.
● If only one PSU is used,
Predicted PSU Status cannot
be set to Active/Standby on
the iBMC WebUI.
5.3 Processor
● The server supports one or two processors.
● If only one processor is required, install it in socket CPU1.
● The same model of processors must be used in a server.
● Contact your local Huawei sales representative or use the Intelligent
Computing Compatibility Checker to determine the components to be used.
Huawei FusionServer Pro 2288X V5 Server
Technical White Paper 5 Hardware Description
Issue 03 (2020-04-20) Copyright © Huawei Technologies Co., Ltd. 21
To Next Page
Loading...
