Huawei IPC6332-MIR - 3.5 Installing Water Resistance Cap

Figure 3-14 Install the Front Cover
Step 5 Tear off the protection film softly to complete the installation.
NOTE
l Do not tear off the protection film until the installation is completed.
l Do not touch the inside face of the bubble with your hands.
----End
3.5 Installing Water Resistance Cap
Purpose
When using the camera outdoor, using a waterproof cap is recommended to prevent the wire
from short circuit.
Procedure
Step 1 Cut the crystal head of a network cable.
Step 2 Route the cable to the secure hook, rubber ring, and the cap.
Step 3 Tuck the rubber ring into the cap.
Step 4 Connect a crystal head for the cable.
Step 5 Put the thin ring on the network cable of the camera side.
Step 6 Connect the network cable and put the water resistance cap on the network interface of the
camera side. Fasten the secure hook.
IPC6332-MIR
Quick Start Guide
3 Installation
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13