2 Installing the Housing of a Box IPC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Step 4 Connect the cable and lead the cable out of the shield through the cable outlet. Close the cover
of the shield and lock the locking knob, as shown in Figure 2-4.
Figure 2-4 Closing and locking the shield
Step 5 Secure the assembled housing onto the bracket using the screws on the housing, as shown in
Figure 2-5.
Figure 2-5 Securing the housing onto the bracket
Step 6 Determine the positions of installation holes based on the installation dimensions of the
bracket and mark the holes. Use a percussion drill bit with a diameter of 8 mm to drill three
holes that are 40 mm deep. Figure 2-6 shows the installation dimensions (in the unit of mm)
of the bracket.
To Next Page
Loading...