8 Installing an Infrared High Speed Dome IPC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Figure 8-2 Fixing the IPC onto the bracket
Step 4 Route the multi-connector cable through the bracket.
Step 5 Install the cover plate on the wall-mounted bracket and fasten the thumb screw, as shown in
Figure 8-3. (The cover plate is available in the accessory kit of the bracket.)
Figure 8-3 Installing the cover plate of the bracket
Step 6 Install the assembled high-speed dome IPC on the wall and fasten the four screws.
----End
Installing the IPC on the Wall When Type-2 Bracket Is Used
Step 1 Determine the positions of installation holes based on the installation dimensions of the
bracket and mark the holes. Use a percussion drill bit with a diameter of 8 mm to drill four
To Next Page
Loading...