Authentication Declaration
This product can be included and operated in any Z-Wave network with other Z-Wave certied
devices from other manufacturers and/or other applications. All non-battery operated nodes
within the network will act as repeaters regardless of vendor to increase reliability of network.
1. Multi-Vendor Sensor Access
This device is a security enabled Z-Wave Plus product that is able to use encrypted Z-Wave
Plus messages to communicate to other security enabled Z-Wave Plus products.
2. Secure Access
This product implements support of the association command class, and the description of the
association groups available is as below:
3. Association Group
4. Processing on Basic Command
Grouping Identier Maximum Number of
Devices in the Group
How the Association Group Is Used
1 5 If the Z-Wave network of this product is
reset, it will send a device reset locally
command to the devices in the group.
If this product receives a basic command, it will do nothing about it.
Operation Guide
To add a sensor, perform the following steps:
1. Adding a Sensor
Step 1 Start the SmartHome app, and log in.
Step 2 On the device management page, touch +. Then add the sensor to the gateway as
prompted step-by-step.
9
To Next Page
Loading...
