Huawei LTE CPE B593 - Page 17

16
Indicator
State
Description
Red
This indicator is constantly red when the CPE fails to
access the wireless network or the CPE does not access
the wireless network.
Mulberry
This indicator is on when the SIM cannot be identified or the
PIN is not entered or the PIN check fails.
Off
This indicator is off when the CPE does not access the
wireless network.
WLAN
On
The WLAN function is enabled.
Blinking
This indicator is blinking when data is transferred through
the WLAN.
Off
The WLAN function is disabled.
LAN1–LAN4
On
This indicator is on when an Ethernet device has been
connected to the relevant port.
Blinking
Data is being transmitted over the corresponding port.
Off
This indicator is off when an Ethernet device is not
connected to the relevant port.
SIGNAL
On
This is a five-bar indicator. The more bars that are on, the
stronger the wireless signals.
Off
This indicator is off when no signal is detected.