Huawei OptiX RTN 600 ODU - Separate Mount Parts for an ODU with the Coaxial Interface; Waveguide-To-Coaxial Converter; Figure 3-5 Appearance of a Waveguide-To-Coaxial Converter

Frequency
Band
Frequency
Range
(GHz)
Flange Type
(Antenna Side/
Flexible Waveguide
Side)
Length
(mm)
Standing
Wave Ratio
28/32/38 GHz 26.3-40.0 UBR320/UBR320 100 1.02
3.2 Separate Mount Parts for an ODU with the Coaxial
Interface
When an ODU with the coaxial interface adopts the separate mount mode, the installation parts
include a waveguide-to-coaxial converter and an RF cable.
3.2.1 Waveguide-to-Coaxial Converter
A waveguide-to-coaxial converter is used to convert the waveguide interface (standard flange
interface) on an antenna into an RF cable interface (type-N interface), for connecting an antenna
and an RF cable.
3.2.2 RF Cable
An RF cable is an FSJ1-50A coaxial cable. It is used to connect a waveguide-to-coaxial converter
to an ODU or to connect a hybrid coupler to an ODU.
3.2.1 Waveguide-to-Coaxial Converter
A waveguide-to-coaxial converter is used to convert the waveguide interface (standard flange
interface) on an antenna into an RF cable interface (type-N interface), for connecting an antenna
and an RF cable.
Appearance
Figure 3-5 Appearance of a waveguide-to-coaxial converter
3 Separate Mount Parts
OptiX RTN 600 ODU
Hardware Description
3-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 06 (2010-05-30)