Huawei PowerCube 500 - Page 13

13
Main Menu
Second-Level Menu
Third-Level
Menu
Fourth-
Level Menu
Default
Value
Setting
Setting
Wizard
Date and Time
Time Zone
-
UTC +08:00
Beijing
Set this parameter to the local time zone.
Date and Time
-
-
Set this parameter to the local date and time.
Network Parameters
IP Address
-
192.168.0.10
Set this parameter based on the IP address
assigned by the network administrator.
Subnet Mask
-
255.255.255.
0
Set this parameter based on the subnet mask
assigned by the network administrator.
Default
Gateway
-
192.168.0.1
Set this parameter based on the gateway address
assigned by the network administrator.
Parameters
Settings
Power System
Basic
Parameters
Battery
Type
Normal Lead
Acid
Set the parameter based on the actual battery type.
Comm.
Parameters
Network
Parameters
NetEco
Primary IP
192.168.0.10
Set an IP address for the active
NetEco server.
NetEco
Backup IP
192.168.0.10
Set an IP address for the standby
NetEco server.
NetEco Port
Number
31220
Please contact Huawei technical support if you
need change the port number.
Battery
Basic
Parameters
Rated
Capacity
100 Ah
Set the parameter based on the actual battery
capacity.
Other
Parameters
Installation
Time
-
Set this parameter to the current time.
ESS
Charge
Parameters
Current
Limit
0.40 C10
0.05C10
–1.00C10
Powering-On the Video Surveillance Equipment
12.4
Switch the M48300N1 circuit breaker to ON.
When the battery type is TCB-
C/FCB-B, this parameter is
displayed.
NOTE
NOTE
When the battery type is ESU-
A/ESM-A, this parameter is
displayed.
13
(Optional) Installing an ICC on a Pole
Upper
fastener
Pole
mounting kit
1. Secure the upper fastener to the
pole mounting kit.
2. Install the upper pole mounting kit
to the pole.
3. Install the lower pole mounting kit to
the support.
4. Install the bracket onto the pole. 5. Hoist the ICC.
6. Secure the ICC.