7
Installing an MA5671 Router Installing an NE05E-SK Router
Installing an AR531 Router
Installing a Network Port SPD and Cables
9.3
4. Install the router communications cable.
5. Install router power cables.
FE
Router
Router power port
If a network port surge
protective device (SPD)
is configured, when
installing the signal
cable for the router,
route the signal cable
through the port on the
network port SPD and
then to the port on the
router.
When installing the NE05E-
SK router, remove the small
tray and install the NE05E-
SK on the big tray.
Installing an Inverter, a PDU, and Cables
9.4
1. Install the inverter and power distribution unit (PDU). 2. Install the ground cables for the inverter and PDU.
SPD
Router
Camera
To Next Page
Loading...
