Huawei PowerCube 5000 - System Working Modes Explained

22
2. Set communications parameters for other devices on the MDU of the master cabinet.
Path
Parameter
Setting
System Info >
Settings >
Communication
Monitor Parallel IP (for a
parallel system)
IP address of the slave cabinet
Lihv Battery Equip IP IP address of the lithium battery cabinet
NetEco Primary IP Set this parameter according to the address
information provided by the network administrator.
NetEcoPort Number Set this parameter as required.
1. Set the language, time, date, network parameters, and system parameters on the Settings
Wizard screen.
The IP address of the lithium battery
cabinet must be the same as the
lithium battery cabinet IP address set
for the ICC cabinet.
Parameter
Setting
EPO detection
EPO (emergency power
-off) is performed only when this parameter is
enabled and the EPO switch is triggered. When
EPO detection is changed
from
Disable to Enable, check that the EPO cable is connected correctly.
Lihv
battery equip IP
The IP address of the lithium battery cabinet must be the same as the lithium
battery cabinet IP address set for the ICC cabinet.