8
2
1
Opening the Charger
1
1. Push the rear cover downwards.
2. Separate the charger body from the rear cover.
Securing the Rear Cover
2
Ensure that the installation surface is solid enough
to hold the charger. It is recommended that the
wall have a bearing capacity of at least 100 kg. Do
not drill holes on the rear cover. Otherwise, the
rear cover may be damaged.
Read the installation precautions before the
installation.
Recommended:
130–140 cm
above the ground
Level
Mounting hole
1. Place the rear cover on the wall, keep it horizontal,
and use a marker to mark the hole drilling positions
on the wall.
2.
Use a hammer drill to drill holes on the wall at the
marked positions, and place wall plugs into the holes.
3.
Use wall-mounting screws to secure the rear cover to
the wall. (Use an M6 Phillips screwdriver with a torque
of 1.4–1.6 N·m.)
x 4
To Next Page
Loading...
