10
Connecting Power Cables
4
1.
correct terminals and tighten the screws clockwise. Pull the power cables to check that the cables are securely
connected. Check that the screws are in the required status. (Use an M5 torque screwdriver with a torque of
2.0±0.2 N·m.)
2.
Select a cable clip based on the cable size. Install the cable clip and use screws to secure the cables. (Use an
M4 torque screwdriver with a torque of 1.2 N·m.)
3.
Pull the power cables to ensure that they are securely connected.
cables are routed in
from the bottom,
it is recommended that
no more than two layers
of cables be stacked.
Recommended cable
diameter: 14.5–19.5 mm
Recommended cable
diameter: 19.5–23 mm
x 2
To Next Page
Loading...
