– S-VLAN ID: 200
– S-VLAN type: smart
– ID of the VLAN containing uplink port 0/4/0: 200 (S-VLAN ID)
huawei(config)#vlan 200 smart
huawei(config)#port vlan 200 0/4 0
2. Configure a service flow to receive and transparently transmit D-CMTS packets.
The following configurations are used as an example to configure a service flow:
– Configuration of the service flow:
– Service flow ID: 1
– S-VLAN ID: 200
– Customer VLAN (C-VLAN) ID: 200
– Device where upstream and downstream packet rates are limited: D-CMTS
In this case, use the default traffic profile with ID 6, which does not limit the rate
of a service flow. To limit packet rates, run the traffic table ip command to create
a traffic profile and bind it to the service flow.
– C-VLAN and S-VLAN of the D-CMTS: same
huawei(config)#service-port 1 vlan 200 gpon 0/3/1 ont 1 gemport 1 multi-
service
user-vlan 200 rx-cttr 6 tx-cttr 6
3. Configure the maximum number of dialup users allowed on a service port.
For functions (such as, MAC address spoofing, anti-IP spoofing, anti-IPv6 spoofing,
DHCP Proxy, IP Aware, IPoE single-MAC, VMAC DHCP aging, NS proxy response,
ARP proxy response, DAD proxy, and DHCPv6 associated routes) depending on
dialup operations performed by DHCP, DHCPv6, PPPoE, and SLAAC users, run this
command to restrict the number of users allowed on each service port.
huawei(config)#security user max-user-count service-port 1 2048
l Configure a CM management channel.
1. Configure a service flow to receive and transparently transmit D-CMTS packets.
The following configurations are used as an example to configure service flows:
– Configuration of a service flow:
– S-VLAN ID: 100
– C-VLAN ID: 100
– Device where upstream and downstream packet rates are limited: D-CMTS
In this case, use the default traffic profile with ID 6, which does not limit the rate
of a service flow. To limit packet rates, run the traffic table ip command to create
a traffic profile and bind it to the service flow.
– C-VLAN and S-VLAN of the D-CMTS: same
huawei(config)#service-port vlan 100 gpon 0/3/1 ont 1 gemport 1 multi-
service
user-vlan 200 rx-cttr 6 tx-cttr 6
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
16 OptiCable D-CMTS Configuration (MA5633 Working as
a Standalone NE)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1785
To Next Page
Loading...
Need help?
General
