Huawei SMU11B - 2 User Interface; 2.1 Installing a Communications Cable; 2.2 Logging In to the WebUI

2 User Interface
2.1 Installing a Communications Cable
Procedure
Step 1 Connect the FE port on the SMU by using a network cable.
Figure 2-1 Installing a communications cable
(1) User WebUI terminal
(2) FE port
----End
2.2 Logging In to the WebUI
Procedure
Step 1 Set the PC IP address in the same network segment as the SMU IP address.
For example, if the SMU has an IP address of 192.168.0.10, a subnet mask of
255.255.255.0, and a default gateway of 192.168.0.1, set the IP address to
SMU11B Site Monitoring Unit
User Manual 2 User Interface
Issue 03 (2022-06-06) Copyright © Huawei Technologies Co., Ltd. 10