Huawei SMU11B - 3.1.2 Logging In to the NetEco

Table 3-1 IP parameters
Main
Menu
Second-
Level
Menu
Third-Level
Menu
Default Value Setting
System
Settings
Network
Cong
IP Address 192.168.0.10 Set this parameter based on the
address assigned by the network
administrator.
Subnet Mask 255.255.255.0 Set this parameter based on the
address assigned by the network
administrator.
Default
Gateway
192.168.0.1 Set this parameter based on the
address assigned by the network
administrator.
Step 4 Set IP addresses and port numbers for the active and standby NetEco servers on
the WebUI.
Table 3-2 NetEco parameters
Main
Menu
Second-
Level
Menu
Third-Level Menu Default Value Setting
System
Settings
NetEco NetEco Primary IP 192.168.0.10 Set this parameter to the IP
address of the active NetEco
server.
NetEco Backup IP 192.168.0.10 Set this parameter to the IP
address of the standby NetEco
server.
NetEco Port
Number
31220 31220
NOTE
Contact Huawei technical support if
you need to change the port
number.
----End
3.1.2 Logging In to the NetEco
Procedure
Step 1 Enter https://NetEco IP address: port number for NetEco login (for example,
https://10.10.10.1:31943) in the address box of the browser and press Enter. The
NetEco login page is displayed.
SMU11B Site Monitoring Unit
User Manual 3 NMS Management
Issue 03 (2022-06-06) Copyright © Huawei Technologies Co., Ltd. 13