Huawei SMU11B - Page 22

Figure 3-4 Setting SNMP parameters
● There are two or more NMSs and the SNMP versions have both SNMPv1 or
SNMPv2c and SNMPv3: Set SNMP Version to ALL in SNMP, and set SNMP
Port Number, Read Community Name, and Write Community Name. Then
click Add in SNMPv3, and set User Name, MD5/SHA Password, and
DES/AES Password. Then click
Conrm.
Figure 3-5 Adding a user
● SNMPv1 or SNMPv2c: Set SNMP Version to SNMPv1&SNMPv2c in SNMP,
and set SNMP Port Number, Read Community Name, and Write
Community Name. Then click
Conrm.
● SNMPv3: Set SNMP Version to SNMPv3 in SNMP, click Add in SNMPv3, and
set User Name, MD5/SHA Password, and DES/AES Password. Then click
Conrm.
Step 3 In SNMP Trap, click Add.
● If the SNMP version is SNMPv1 or SNMPv2c, set Trap Target Address, Trap
Port, and Trap Community.
SMU11B Site Monitoring Unit
User Manual 3 NMS Management
Issue 03 (2022-06-06) Copyright © Huawei Technologies Co., Ltd. 16