Huawei SUN2000-100KTL-M2 - Power-Off for Troubleshooting

No. Parameter Description Remarks
3 Maximum apparent
power (kVA)
Species the output upper
threshold for the maximum
apparent power to adapt to the
capacity requirements of standard
and customized inverters.
If the maximum active power
equals the value of
Smax_limit, this parameter is
not displayed.
4 Maximum active
power (kW)
Species the output upper
threshold for the maximum active
power to adapt to dierent
market requirements.
-
5 Shutdown at 0%
power limit
If this parameter is set to Enable,
the inverter shuts down after
receiving the 0% power limit
command. If this parameter is set
to Disable, the inverter does not
shut down after receiving the 0%
power limit command.
-
6 Active power
change gradient
(%/s)
Species the change speed of the
inverter active power.
-
7 Derated by active
power % (0.1%)
Adjusts the active power output
of the inverter by percentage.
If this parameter is set to 100,
the inverter outputs based on
the maximum output power.
8 Active power
derating in
absolute power
(kW)
Adjusts the active power output
of the inverter by xed value.
-
9 Reactive power
change gradient
(%/s)
Species the change speed of the
inverter reactive power.
-
10 Reactive power
adjustment time
(s)
Species the adjustment time for
the reactive power to reach the
target value during reactive
power adjustment.
-
11 Power factor Species the power factor of the
inverter.
-
12 Reactive power
compensation
(Q/S)
Species the reactive power
output by the inverter.
-
SUN2000-(100KTL, 110KTL, 115KTL)-M2
User Manual 7 Man-Machine Interactions
Issue 07 (2023-04-30) Copyright © Huawei Technologies Co., Ltd. 96