500 meters from the coast or prone to sea breeze. The regions prone to sea
breeze vary with weather conditions (such as typhoons and monsoons) or
terrains (such as dams and hills).
Mounting Structure Requirements
● The mounting structure where the solar inverter is installed must be re
resistant. Do not install the solar inverter on ammable building materials.
● Ensure that the installation surface is solid enough to bear the solar inverter.
● In residential areas, do not install the solar inverter on drywalls or walls made
of similar materials with a weak sound insulation performance because the
noise generated by the solar inverter may interfere with residents.
Figure 4-1 Mounting structure
Installation Angle Requirements
The solar inverter can be support-mounted or wall-mounted. The installation
angle requirements are as follows:
● Install the solar inverter vertically or at a maximum back tilt of 75 degrees to
facilitate heat dissipation.
● Do not install the solar inverter at forward tilted, excessive back tilted, side
tilted, horizontal, or upside down positions.
SUN2000-(100KTL, 110KTL, 115KTL)-M2
User Manual 4 Installation
Issue 07 (2023-04-30) Copyright © Huawei Technologies Co., Ltd. 31
To Next Page
Loading...
