Huawei UPS2000-G-6KRTLL - Starting the Inverter

11
Code
Display
Description
Code
Display
Description
00
Exit the setting mode
09
Online
mode(default)
01
Forcibly exit the
fault mode
(disabled by default)
Automatic mode
Enable the function of forcibly
exiting the fault mode. 10s
after you exit the setting
screen, the UPS exits the fault
mode and clears the critical
alarm.
ECO mode
02
Maximum charge current
10
Disable battery
discharge test
(default).
03
Output voltage
Enable battery
discharge test.
04
Number of parallel UPSs
11
SOC percentage
05
Battery discharge time
12
Buzzer on
(default)
07
Battery capacity setting
Buzzer off
08
Output frequency
For details about parameter settings, see the UPS2000-G-6KRTLL User Manual .
Common Settings
Starting the Inverter
5.2
On the standby screen, press and hold down ON/MUTE for more than 5 second. Release the
button when you hear a beep tone. If the UPS starts successfully, it enters the normal mode.
After you ensure that the UPS runs properly, switch on the AC output circuit breaker on the UPS
and start loads.
All manuals and user guides at all-guides.com