● Four 40GE optical interfaces are provided by default. You can run the set device port-
cong-mode 100g-port enable command to switch 40GE0/0/2 and 40GE0/0/3 to
100GE optical interfaces. After that, their interface numbers are changed to 100GE0/0/0
and 100GE0/0/1. However, when 100GE optical interfaces are used, 10GE optical
interfaces numbered XGE0/0/12 to XGE0/0/19 are unavailable.
● The power cable varies according to the delivery country.
Cable Connection
Connect cables according to Figure 2-22 and power on the device. As device does
not provide a power switch, it starts up immediately after receiving power. When
the SYS indicator on the frontpanel is blinking (once every two seconds), the
device is running and ready for conguration.
Figure 2-22 Connecting cables of USG6712E, USG6716E
HUAWEI USG6000E Series Quick Start 2 Device Introduction and Cable Connection
Issue 02 (2022-08-22) Copyright © Huawei Technologies Co., Ltd. 25
To Next Page
Loading...
