Huawei V100R001 - Access Control System; Access Actuator

FusionModule5000 Smart Modular Data Center
Product Description (ECC800)
79
Indicat
or
Col
or
Name
Status
Description
RF_Z
Gree
n
Communication
status indicator
Steady on
No network parameters exist, or a
network is to be created.
Blinking at
long intervals
A network is set up, and no node
access is allowed (the indicator
blinks at 0.5 Hz, on for 1s and then
off for 1s).
Blinking at
super short
intervals
A network is set up, and node
access is allowed (the indicator
blinks at 10 Hz, on for 0.05s and
then off for 0.05s).
Blinking
intermittently
at super short
intervals
The skylight actuator is searching
for a network (the indicator blinks
at super short intervals for 0.5s and
then turns off for 0.5s).
Communications Ports
The skylight actuator provides one DO port (LOCK/GND) and one DI port (BUTTON/GND).
Table 3-48 lists the LOCK/GND/BUTTON/GND port pin definitions.
Table 3-48 LOCK/GND/BUTTON/GND port pin definitions
Item
Description
LOCK/GND
pin sequence
LOCK
12V_OUT
GND
GND
BUTTON/GN
D pin
sequence
BUTTON
DI3
GND
GND
3.4.7 Access Control System
3.4.7.1 Access Actuator
The access actuator is the control component for the aisle door in a Smart Module. It connects
to the ECC800 controller system over FE port, wireless networking (802.15.4), or RS485 port.
It opens the magnetic lock by detecting the card swiping information of the card reader, door
open button information, and fire linkage information. It has access right management, access
event record, and alarm record functions.
Figure 3-54 shows an access actuator.