Hubner EGS 40 K User Manual

Electronic Overspeed Switch EGS 40
EGS40_MANUAL-en_R6(2018-11-07)ID74528.docx
7
2.3 Improper use
 Do not use the device in potentially explosive areas.
 The device must not be subjected to mechanical loads in addition to its own weight and
unavoidable vibration and shock loads that arise during normal operations.
Examples for non-permitted mechanical loads (incomplete list):
- Fastening transport or lifting tackle to the device, for example a crane hook to lift a
motor.
- Fastening packaging components to the device, for example ratchet straps, tarpaulins
etc.
- Using the device as a step, for example by people to climb onto a
motor.
 It is not permitted to use the device in locations higher than 3000 m above sea level.
2.4 Personal protective equipment
For tasks such as assembly, disassembly or commissioning the use of personal protective equipment
such as safety footwear and protective work clothing is required.
The regulations specified by the owner and that are locally specified apply.
2.5 Special dangers
Residual risks that have been determined based on a risk analysis are cited below.
2.5.1 Electrical current
DANGER!
Life-threatening danger due to electrical shock!
There is an imminent life-threatening hazard if live parts are touched. Damage to
insulation or to specific components can pose a life-threatening hazard.
Therefore:
Immediately switch off the device and have it repaired if there is damage to the
insulation of the power supply.
De-energize the electrical equipment and ensure that all components are connected
for all tasks on the electrical equipment.
Keep moisture away from live parts. Moisture can cause short circuits.
2.5.2 Rotating shafts
WARNING!
Danger of injury due to rotating shafts!
Touching rotating shafts can cause serious injuries.
Therefore:
Do not reach into moving parts/shafts or handle moving parts/shafts during
operation.
Do not open covers during operation. Prior to opening the covers ensure that all
parts have come to a standstill.
2.5.3 Safeguarding against restart
DANGER!
Life-threatening danger if restarted without authorization!
When correcting faults there is danger of the power supply being switched on
without authorization.
This poses a life-threatening hazard for persons in the danger zone.
Therefore:
Prior to starting work, switch off the system and safeguard it from being switched on
again.

Hubner EGS 40 K Specifications

General

Brand	Hubner
Model	EGS 40 K
Category	Switch
Language	English