4
2024 Series Tooling Alcoa Fastening Systems
This instruction manual must be read with
particular attention to the following safety
guidelines, by any person servicing or operating
this tool.
1
Safety Glossary
WARNINGS - Must be understood
to avoid severe personal injury.
CAUTIONS - show conditions that will damage
equipment and/or structure.
Notes-are reminders of required procedures.
Bold, Italic type and underlining -
emphasizes a
specific instruction.
2 Huck equipment must be maintained in a safe
working condition at all times and inspected on a
regular basis for damage or wear. Any repair should
be done by a qualified repairman trained on Huck
procedures.
3 Repairman and Operator must read and understand
any Warning and Caution stickers/labels supplied
with equip-ment before connecting equipment to any
primary power supply - - as applicable, each of the
sections in this manual have specific safety, and
other information.
4 When repairing or operating Huck installation
equipment always wear approved eye protection.
Where applicable, refer to ANSI Z87.1 - 1989
5 Disconnect primary power source before doing
maintenance on Huck equipment.
6 If any equipment shows signs of damage, wear or
leakage, do not connect it to the primary power
supply.
7 Make sure proper power source is used at all times.
8 Never remove any safety guards or pintail deflector.
9 Never install a fastener in free air, personal injury
from fastener ejecting may occur.
10 Do not abuse tool by dropping or using it as a
hammer. Reasonable care of installation tools by
operators is an important factor in maintaining tool
efficiency, eliminating downtime and in preventing an
accident which may cause severe personal injury.
S
S
AFETY
AFETY
Service Notes
To Next Page
Loading...
