HuddleCamHD 10XA - Page 7

Ver. 1.0 – 10/17
• Scan Speed (Auto Pan Mode) Default Value: 6
o Set speed of boundary scan
▪ Range = 1 – 63
• Tour Path (Uses presets) Default Value: 1
o Select desired tour path
▪ Range = 1 – 4
• Tour Dwell Default Value: 5
o Set duration to dwell on each preset
▪ Range = 1 – 60
• Proportion Default Value: On
(Pan + Tilt speed proportional to zoom level)
o Set Proportion
▪ Range = On – Off
• Auto Rev Default Value: P
o Set camera mounting orientation
▪ N for inv ceiling mount, P for std. mount
• Frame Default: 60Hz
o Set Refresh Rate
▪ Range = 50Hz or 60Hz
• Preset Freeze Default: On
o Provides automatic temporary freeze frame when switching between presets
▪ Range = On – Off
• POS COMEBACK
o Allows the camera to revert to last position left at for 30+ seconds
▪ Range = On = Off
Lens____________________________________________________________
• BL (Backlight) Default Value: OFF
o ON/OFF
• Saturation Default Value: 9
o 0 – 15
• Sharpness Default Value: 3
o 0 – 15
• NR (Noise Reduction) Default Value: Auto
o Adjustable Value: OFF, AUTO, 1 – 4
• WB (White Balance) Default Value: Auto
o Auto/Indoor/Outdoor/Onepush/ATW/Manual