Need help?Do you have a question about the Hughes & Kettner ATTAX 100 Combo and is the answer not in the manual?
General| Brand | Hughes & Kettner |
|---|---|
| Model | ATTAX 100 Combo |
| Category | Amplifier |
| Language | English |
How to select channels and adjust effect parameters using buttons and the FX MATRIX.
Connecting guitars and adjusting channel/master volume levels.
Instructions for operating the power switch and connecting the mains cable.
Connecting external speakers to the ATTAX 100, detailing impedance requirements.
Connecting headphones and adjusting volume.
Outputting the amp's signal to other devices or a DI box.
Connecting line signals like CD players for practice.
Connecting external effect devices via the serial effects loop.
Connecting and using the footswitch for channel selection.
Using a footswitch to turn internal effects on/off individually.
How to program the FX ON/OFF function for different footswitch configurations.
Description of the CLEAN channel, its volume and voicing controls.
Adjusts the volume level for the CLEAN channel.
Controls BASS, MID, and TREBLE for the CLEAN channel.
Description of the CRUNCH channel, its gain and volume controls.
Controls input sensitivity and saturation for the CRUNCH channel.
Adjusts the CRUNCH channel's volume level.
Description of the LEAD channel, its gain and volume controls.
Controls input sensitivity and saturation for LEAD and ULTRA channels.
Adjusts the LEAD channel's volume level.
Description of the ULTRA channel, its volume control.
Adjusts the ULTRA channel's volume level.
Shared EQ controls for CRUNCH, LEAD, and ULTRA channels.
Controls CHORUS, FLANGER, and TREMOLO effects.
Description of the CHORUS effect and its settings.
Description of the FLANGER effect and its settings.
Description of the TREMOLO effect and its settings.
Controls the DELAY effect, including time and feedback.
Controls the REVERB effect volume.
To Next Page