Need help?Do you have a question about the Hughes & Kettner GRANDMEISTER DELUXE 40 and is the answer not in the manual?
General| Power Output | 40 Watts |
|---|---|
| Preamp Tubes | 3 x 12AX7 |
| Power Tubes | 4 x EL84 |
| Channels | 4 |
| Effects | Reverb, Delay, Modulation |
| MIDI Control | Yes |
| Weight | 7.7 kg |
| Switchable Power | Yes |
| Channel Types | Clean, Crunch, Lead, Ultra |
| Speaker Outputs | 1 x 8 Ohm, 1 x 16 Ohm |
| Smart Rotary Controls | Yes |
| Effects Loop | Yes |
| USB | Yes |
| Dimensions | 445 x 170 x 150 mm |
| Controls | Gain, Volume, EQ, Presence, Master |
| Red Box | Yes |
Important steps and precautions before powering on the amplifier.
Connects a speaker cabinet designed for guitar amps.
Details on powering on and using the standby switch.
Guitar input and MIDI connections for control and presets.
Knob position may not reflect preset setting; Store LED indicates match.
How to switch presets using MIDI controllers.
Using the FSM-432 for bank and preset selection, and mode switching.
Steps to store current settings into a preset.
Align physical knob position with stored preset values.
Connecting expression pedals or footswitches for remote control.
Using the iPad app for remote control and preset management.
Description of the four channels: Clean, Drive, Lead, Ultra.
Details on Gain, Boost, and Bass, Mid, Treble controls.
Introduction to Reverb, Delay, Modulation FX, and Noise Gate.
Controls for Dly Level, Feedback, and Dly Time.
Modulation types, intensity, and the FX loop function.
Master, Resonance, and Presence knobs for overall tone.
Connecting speaker cabinets and impedance considerations.
Adjusting output power for different volume levels.
Controls for cabinet emulation voicing, size, and level.
System for monitoring and maintaining power tube health.
Adjusting the noise gate's Hard/Soft sensitivity.
Ports for connecting external gear and pre-amp signal.
Explains TSC's role in bias adjustment and tube longevity.
Interpreting LED indicators for tube status and errors.
Procedure to check tube bias points using LEDs and a pick.
Configuring MIDI channels and Omni On/Off status.
Activating and deactivating Global Power Soak and EQ modes.
List of editable functions and their corresponding controller numbers.
Steps to perform a factory reset on the amplifier.
Automatic power-off mechanism to save energy.
Specifications for preamp tubes, power tubes, output, and more.
To Next Page