EasyManua.ls Logo

Hummer H2 2010 - Lockout Protection

Hummer H2 2010
552 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Security Lock Label shown
The rear door security
locks are located on the
inside edge of each rear
door. The rear doors must
be open to access them.
The label depicting lock
and unlock positions is
located near the lock.
To set the locks:
1. Insert the key into the security lock slot and turn it
so the slot is in the horizontal position.
2. Close the door.
To open a rear door when the security lock is on:
1. Unlock the door by lifting the rear door manual
lock, by pressing the power door lock switch, or if
the vehicle has one, by using the Remote Keyless
Entry (RKE) transmitter.
2. Open the door from the outside.
To cancel the rear door security lock:
1. Unlock the door and open it from the outside.
2. Insert the key into the security lock slot and turn it
so the slot is in the vertical position.
Lockout Protection
This feature protects you from locking your key in the
vehicle when the key is in the ignition and a door
is open.
If the driver side power lock switch is pressed when a
door is open and the key is in the ignition, all of the
doors will lock and then the driver door will unlock.
If the passenger side power lock switch is pressed
when a door is open and the key is in the ignition, all of
the doors will lock and then the passenger door will
unlock.
3-11

Table of Contents

Related product manuals