Rocking Your Vehicle to Get It Out
Turn the steering wheel left and right to clear the area
around the front wheels. The traction control system
activates when the system senses that the wheels are
spinning. Shift back and forth between R (Reverse) and
a forward gear, spinning the wheels as little as possible.
To prevent transmission wear, wait until the wheels stop
spinning before shifting gears. Release the accelerator
pedal while you shift, and press lightly on the
accelerator pedal when the transmission is in gear.
Slowly spinning the wheels in the forward and reverse
directions causes a rocking motion that could free the
vehicle. If that does not get the vehicle out after a few
tries, it might need to be towed out. Or, you can use the
recovery loops. If the vehicle does need to be towed
out, see Towing Your Vehicle on page 5‑46.
Recovery Loops
{
WARNING:
These loops, when used, are under a lot of force.
Keep people away from the vicinity of the loops
and any chains or cables during use. Always pull
the vehicle straight out. Never pull on the loops at
a sideways angle. The loops could break off and
you or others could be injured from the chain or
cable snapping back.
Notice: Never use the recovery loops to tow the
vehicle. The vehicle could be damaged and it would
not be covered by the vehicle warranty.
5-36
To Next Page
Loading...
