Hummer H2 2010 - Front Turn Signal and Parking Lamps

4. Unplug the electrical
connector.
5. Pull the old bulb straight out of the bulb socket.
6. Push the new bulb socket into the headlamp
assembly aligning the bulb socket with the
headlamp assembly. Do not to touch the bulb with
your fingers or hands.
7. Turn the bulb socket retainer clockwise to lock it
into place.
8. Plug in the electrical connector.
Front Turn Signal and Parking
Lamps
To replace a front turn signal or parking lamp bulb:
1. Open the hood. See Hood Release on page 6‑14.
2. Turn the bulb socket
counterclockwise and
remove it from the
lamp housing.
3. Pull the bulb from the bulb socket.
4. Push the new bulb straight into the socket until it
clicks.
5. Turn the bulb socket clockwise until it locks into
place.
6-53