1. Installation Preparation
Following are instructions for the installation of this accessory. Before you start installation, we encourage
you to read these instructions carefully in order to get the full benefit from your Humminbird accessory.
Supplies: In addition to the hardware included in this box, you will need a separate 12 or 24 VDC power
supply from that used for engine start, adhesive tape, a powered hand drill and various drill bits, various
hand tools, safety glasses, and a dust mask.
NOTE: It is important that you have read and understood the warnings and cautions provided in the
Important Information section of this manual before proceeding with the installation.
NOTE: A separate 12/24 VDC power supply is required for the Radar scanner installation to prevent erratic
behavior and data loss, which can occur if the engine start does not have a separate power supply.
1. Review the Box Contents
Also, see the Specifications section for additional product information.
1. Unpack the box and confirm the contents with the illustration shown below.
CAUTION! Do not remove the cover from the unit. There are no connections or adjustments inside
the unit that are needed for installation or operation.
NOTE: Product supplies and features are subject to change without notice.
Parts Supplied
(1) Radar scanner
(1) AS EC M12
to RM data cable
(32.8 ft [10 m])
(1) power cable
(32.8 ft [10 m])
(4) flat washers
(4) spring washers
(4) M8 mounting bolts
2
Installation Preparation
2. D
Dep
acce
insta
Also
3. C
A sc
or m
•
•
O
CHIRP_Radar_Install_Manual_532523-1EN_A.qxp_Layout 1 8/11/16 10:48 AM Page 2
To Next Page
Loading...
